5.1.2 Using the automatic document feeder

(KX-MB2010/KX-MB2030 only)

MCopyN
MStopNMStartN
* The pictured model is KX-MB2010.
1If the MCopyN light is OFF, turn it ON by pressing
MCopyN.
2Set the original (page 20).
3If necessary, change the copy size (original
document size and recording paper size), resolution
and contrast according to the type of document.
RTo select the copy size, see page 34.
RTo select the resolution, see page 34.
RTo select the contrast, see page 34.
4If necessary, enter the number of copies (up to 99).
5MStartN
RThe unit will start copying.
6After you finish copying, press MStopN to reset the
settings you set in step 3 and 4.
Note:
RTo stop copying, see page 72.
5.2 More copying features
RMake sure that the MCopyN light is ON.

5.2.1 Zoom copy (enlargement / reduction)

1Set the original (page 19).
2Press MZoomN repeatedly to select the zoom rate that
fits the size of your document and recording paper.
–“ZOOM =100%”*1
–“50%”
–“200%”
*1 Press MCN or MDN repeatedly to change the zoom
rate by 1 % at a time from “25%” to “400%”.
You can also enter the desired percentage
specifically by using the dial keys.
3MSetN
4If necessary, enter the number of copies (up to 99).
A MStartN
5After you finish copying, press MStopN to reset this
feature.
Note:
RZoom copy is not available for the following features:
– Quick ID copy feature (page 36)
– Image repeat feature (page 36)
– Poster feature (page 38)
– N in 1 feature (page 38)
– Separate N in 1 feature (page 39)
RYou can hold the previous zoom setting (feature #468
on page 63).
RWhen using the scanner glass, the unit will only
enlarge the right top corner of the document starting
from the mark on the unit.
RWhen using the automatic document feeder, the
unit will only enlarge the center of the upper part of
the document. To make an enlarged copy of the
bottom of the document, turn the document around,
and then make a copy (KX-MB2010/KX-MB2030
only).
35
5. Copier