Original document Page layout
“8 in 1” “PORTRAIT”
“LANDSCAPE”
Note:
RYou can save the previous page layout setting
(feature #467 on page 63).
Separate N in 1 feature (Scanner glass only)
You can separate an N in 1 copied document back into
its original, separate pages. This feature is available for
documents created using the “2 in 1” and “4 in 1”
settings.
1. Set the original (page 19).
2. Press MPage LayoutN repeatedly to select “PAGE
LAYOUT”.
3. Press MCN or MDN repeatedly to select “SEPARATE N
in 1”. A MSetN
4. Press MCN or MDN repeatedly to select the number of
original documents from “2 in 1” or “4 in 1”.
A MSetN
5. Press MCN or MDN repeatedly to select the page layout
of the original document from “PORTRAIT” or
“LANDSCAPE”. A MSetN
6. If necessary, enter the number of documents (up to
99). A MStartN
7. After you finish copying, press MStopN to reset this
feature.

5.2.6 Edge feature

You can set the unit not to copy the outer edges of the
document without reducing the copied documents to fit
the recording paper. This is useful for copying
documents with dirty edges.
Note:
RThis feature and page layout features cannot be used
at the same time (except for N in 1).
1Set the original (page 19).
2Press MPage LayoutN repeatedly to select “EDGE”.
3Press MCN or MDN repeatedly to select “ON”. A
MSetN
4Press MCN or MDN repeatedly to select “LONG EDGE”.
A MSetN
5Enter the desired edge width of long edge using the
dial keypad. A MSetN
6Press MCN or MDN repeatedly to select “SHORT
EDGE”. A MSetN
7Enter the desired edge width of short edge using the
dial keypad. A MSetN
8MStartN
9After you finish copying, press MStopN to reset this
feature.
Note:
RYou can hold the previous edge setting (feature #473
on page 63).

5.2.7 Margin feature

You can set the unit not to copy a particular edge of the
document to make a margin. This is useful for binding
the copied documents.
Note:
RTo automatically reduce the copies according to the
set margin, see feature #474 on page 63.
RThis feature and page layout features cannot be used
at the same time.
1Set the original (page 19).
RTo make a portrait copy, set the original in portrait
direction. To make a landscape copy, set the
original in landscape direction.
2Press MPage LayoutN repeatedly to select
“MARGIN”.
3Press MCN or MDN repeatedly to select “ON”. A
MSetN
4Press MCN or MDN repeatedly to select the page layout
from “PORTRAIT” or “LANDSCAPE”. A MSetN
5Press MCN or MDN repeatedly to select the edge you
want to set the margin for from “TOP”, “RIGHT”,
“LEFT” or “BOTTOM”. A MSetN
6Enter the desired margin width using the dial keypad.
A MSetN
7MStartN
8After you finish copying, press MStopN to reset this
feature.
Note:
RYou can hold the previous margin setting (feature
#475 on page 63).

5.2.8 Copy reservation

You can make a copy reservation under the following
conditions:
– while the unit is printing documents from your
computer.
– while the unit is printing received fax documents
(KX-MB2030 only).
39
5. Copier