Panasonic PT-AX100E manual Wss, Over Scan, Keystone, Auto Setup, Aspect ratio depend on signals

Aspect ratio depend on signals

Press I H to cycle through the aspect ratio options. The cycle pattern depends on the connected signals.

	4:3 \ 16:9 \ 14:9 \ JUST \
VIDEO/	ZOOM1 \ ZOOM2
	AUTO \ 4:3 \ 16:9 \ JUST \
S-VIDEO
	ZOOM
	NTSC signal
	4:3 \ 16:9 \ V SCROLL
	4:3 \ 16:9
	VGA or SVGA signals
PC (RGB)	V SCROLL only
	WIDE768
	Not switchable
	WIDE480/600/720/768-2 signals
	4:3 \ 16:9
	16:9 \ H - FIT \ V - FIT \ ZOOM
	1 125 (1 080)/50i, 1 125 (1 080)/60i,
HDMI	1 125 (1 080)/50p, 1 125 (1 080)/60p,
	1 125 (1 080)/24p, 750 (720)/50p and
	750 (720)/60p signals
	4:3 \ 16:9 \ JUST \ ZOOM
	525p (480p) and 625p (576p) signals
	4:3 \ 16:9 \ 14:9 \ JUST \
	ZOOM1 \ ZOOM2
	625i (576i), 625p (576p)
	AUTO \ 4:3 \ 16:9 \ JUST \
	ZOOM
YPBPR	525i (480i), 525p (480p)
	16:9 \ H - FIT \ V - FIT
	1 125 (1 080)/50i, 1 125 (1 080)/60i,
	1 125 (1 080)/50p, 1 125 (1 080)/60p,
	1 125 (1 080)/24p, 750 (720)/50p,
	750 (720)/60p signals

WSS

If a PAL/625p (576p)/625i (576i) signal is input and that signal has an identification signal, the aspect ratio is automatically switched to the required setting. You can switch the system off manually.

OVER SCAN

If the 4 edges of an image is partly dropped, you can use this function to adjust and project it properly.

Shrink Enlarge

Setting range: 0 to +10

OVER SCAN is not available with PC signals.

POSITION Menu

KEYSTONE

If the projector is aligned non-perpendicularly to the screen, or if the projection screen has an angled surface, you can vertically correct keystone.

Image Operation

Setting range: -32 to 32

NOTE:

You can correct the distortion ± 30 degrees from the vertical plane. For a better quality image, installing the projector with a minimum of distortion is recommended.

Some distortion may be retained for Lens shift adjustment.

The distortion of the Main menu screen is not correctable.

The result of the keystone correction will affect on the aspect ratio and the size of the image.

AUTO SETUP

You can adjust V - POSITION, H - POSITION, DOT CLOCK and CLOCK PHASE automatically when connecting via PC. Press ENTER to adjust these at the same time.

Settings

ENGLISH - 33