Panasonic PT-AX100E manual Installation, Sleep, Altitude, Lamp Power, Lamp Runtime, Test Pattern

INSTALLATION

When installing the projector, select the projection method according to the projector position. Press I H to cycle through the options. See “Projection method” on page 15.

FRONT/DESK	Setting on a desk/floor and
	projecting from front
FRONT/CEILING	Mounting in the ceiling and
	projecting from front
REAR/DESK	Setting on a desk/floor and
	projecting from rear
REAR/CEILING	Mounting in the ceiling and
	projecting from rear

SLEEP

You can select the required duration of time and set the off timer to turn off the POWER of the projector automatically. 3 minutes before turn-off, the countdown of minutes will be displayed in the lower right corner. Press I H to cycle through the options. See “Switching off the projector automatically” on page 23.

ALTITUDE

If you use the projector at high elevations, set the fan speed to HIGH. Press I H to select HIGH or LOW.

NOTE:

At 1 400 m (4593 ft) above sea level, the setting must be HIGH.

LAMP POWER

You can adjust the power of the lamp to save on electricity, prolong the lamp life and reduce the noise.

Options	Function
NORMAL	When higher luminance is
	required such as movies
ECO - MODE	When lower luminance is
	sufficient such as in a small room

NOTE:

When no input signal is detected, the function is disabled.

OPTION Menu

LAMP RUNTIME

You can check how long time has been the lamp used.

NOTE:

LAMP RUNTIME is a relevant matter for lamp replacement timing. See “Care and Replacement” on page 37.

TEST PATTERN

You can use the 2 different of test pattern to adjust the focus of the image. The PICTURE MODE is switched to DYNAMIC temporarily, and return to the last used setting when return to projection.

1.Press ENTER to display test pattern 1 and adjust the focus with the Focus ring.

2.Press ENTER to display test pattern 2 and adjust the focus with the Focus ring again.

3.Press MENU or RETURN to return to the previous menu, or press repeatedly to return to the screen.

NOTE:

While a test pattern is displayed, the PICTURE MODE is changed temporarily to DYNAMIC. When the projector and/or the screen is tilted, adjust the focus at the centre of the image. The upper and lower edge might be out of focus. When the image is distorted in keystone, adjust the KEYSTONE in POSITION menu.

Settings

ENGLISH - 35