Settings

Setting

HDMI setup

This function is only used for HDMI input source.

1111Press ▲▼ to select [HDMI setup].

2222Press ► or the <ENTER> button.

zzThe names for the output setting of Digital R/G/ B vary from equipment to equipment.

JJHDMI signal level

64-940

When the output of Digital R/G/B

 

equipment is set to Standard.

0-1023

When the output of Digital R/G/B

 

equipment is set to Enhanced.

JJSound

HDMI

When Digital input source is input,

Sound is set to HDMI.

 

AUDIO 1

When DVI input source is changed

to HDMI input source, Sound is set

 

to AUDIO 1.

Note

zzFor details, refer to the operating instructions of your Digital R/G/B equipment.

DVI signal level

This function is only used for DVI-D input source.

1111Press ▲▼ to select [DVI signal level] and then press the <ENTER> button.2222Press ▲▼ to switch the item.

16-235When you want to enhance the weaken signal.

0-255:PCWhen in normal condition.

Lamp power

This function allows you to change brightness of the screen.

1111 Press ▲▼ to select [Lamp power] and then press the <ENTER> button .2222 Press ▲▼ to select one among the modes as below.

Auto

Brightness according to the input

signal.

 

Normal

The lamp power output is

maximum.

 

Eco1

The lamp power output is 80%

of the Normal mode.

 

Eco2

The lamp power output is 30% -

80% of the Normal mode.

 

Fan control1111 Press ▲▼ to select [Fan control] and then Press <ENTER> button.2222 Press ▲▼ to select one among options as below.

zzChoose the running speed of cooling fans from the following options according to the ground elevation under which you use the projector.

Off Normal speed.*1

On 1 Faster than [Off] mode.*2

On 2 Faster than [On 1] mode.*3

*****Set this function to [Off] when using the projector in non-high altitude environment.

*****Select [On 1] when using the projector in high altitudes (about 1 000 ~ 2 000 meters or more above the sea level) where the fans have less cooling effect.

*****Select [On 2] when using the projector in higher altitudes (about 2 000 ~ 2 800 meters or more above the sea level) where the fans have lesser cooling effect.

Note

zzFailure to set the running speed of cooling fans properly may affect the projector life.

zzThe fan noise becomes louder in [On 1] and [On 2].

66 - ENGLISH