Network

JJE-mail set up page

With this projector, if a problem occurs or if the lamp usage time reaches a set value, an e-mail message can be sent to one or more preset e-mail addresses (maximum two addresses).

Click [Detailed set up], then [E-mail set up] to display the E-mail setup page.

1Select Enable to use the e-mail function.

2Enter the IP address or server name of the e-mail server (SMTP). The DNS server must be set if the server name is entered.

3Enter the e-mail address of the projector.

(maximum 63 characters)

4The user can enter the location of, for example, the installed projector so that the recipient may easily identify the originator of the e-mail.

(maximum 63 characters)

5

6

1

2

3 4

5

6

The user can modify the minimum time interval of temperature warning mail. The default value is 60 minutes. In this case, the user cannot send another mail for 60 minutes after sending previous temperature warning mail even the set warning temperature is reached again.

Select the temperature of the intake sensor at which to send a warning message.

1

2

Settings

1Enter the E-mail Address1 of your desired recipient.

2Select the conditions for sending e-mail.

MAIL CONTENTS:

Select [NORMAL] or [SIMPLE].

ERROR:

An error is detected by self-diagnosis.

LAMP RUNTIME:

Remaining lamp service time has reached the value set in the field.

INTAKE AIR TEMPERATURE:

Intake air temperature has reached the value set in the field.

ENGLISH - 83