Settings

Setting

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

1111Press ▲▼ to select [Power management].

2222Press ► or the <ENTER> button to access the submenu.

JJMode

1111Press ▲▼ and then press the <ENTER> button to select one mode among the items as below.

Ready

When the lamp has been fully cooled

 

down, the <ON(G)/STANDBY(R)>

 

indicator changes to green blinking.

 

In this condition, the projection lamp

 

will be turned on if the input signal

 

is reconnected or any button on

 

the side control or remote control is

 

pressed.

Shut

When the lamp has been fully cooled

down

down, the power will be turned off.

Off

[Power management] function is off.

JJTimer1111Press ▲▼ to select [Timer] and then press the <ENTER> button.2222Press ▲▼ to set the Timer(1~30min).Standby mode

This function can set the electric power when the projector is standing by.

1111Press ▲▼ to select [Standby mode] and then press the <ENTER> button.2222Press ▲▼ to switch between the items as below.

Normal The normal situation.

Eco The power less than 0.5W.

Network The power less than Normal.

Note

zzWhen selecting [Network], the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

zzIf [Standby mode] is set to [Eco], you cannot use network functions when the projector is standing by. Also, you cannot use some RS-232C protocol commands.

zzIf set to [Network], you can use network functions when the projector is standing by.

Direct on1111 Press ▲▼ to select [Direct on] and then press the <ENTER> button.2222 Press ▲▼ to switch between [On] and [Off].

zzWhen this function is set to [On], the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.

zzBe sure to turn off the projector properly. If the projector is turned off in the incorrect sequence, the [Direct On] function does not work properly.

P-timer

This function allows you to change the setting of the P-timer and execute it.

1111 Press ▲▼ to select [P-timer].2222 Press ► or <ENTER> button to access the submenu.

JJMode

1111 Press ▲▼ button to select one mode among the items as below.

The P-timer display 000:00

Count up appears on the screen and the count up starts (000:00-180:00).

The time set in the Timer setting Count down appears on the screen and the

countdown starts.

JJTimer

1111 Press ▲▼ to select [Timer] and then press the <ENTER> button.2222 Press▲▼ to set the [Timer](1-180 Min).

zz[Timer] is available in [Count down] only. Factory default value is 10 Min.

68 - ENGLISH