Maintenance

Replacement

JJLamp unit

The lamp unit is a consumable component. You can check the total usage time using Lamp runtime in the Information menu on page 72.

It is recommended to ask an authorized engineer to replace the lamp unit. Contact your dealer. Consult your dealer to purchase a replacement lamp unit (ET-LAE200).

CAUTION:

■Do not replace the lamp unit when it is hot. (Wait at least 1 hour after use.)

The inside of the cover can become very hot, take care to avoid burn injuries.

JJNotes on the replacement of the lamp unit

zzThe luminous source of the lamp is made of glass and may burst if you hit it against a hard surface or drop it.

Please handle with care.

zzA Phillips screwdriver is required for replacement of the lamp unit. zzWhen replacing the lamp unit, be sure to hold it by the handle. zzWhen replacing the lamp because it has stopped illuminating,

there is a possibility that the lamp may be broken. If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when

the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately. zzThe lamp contains mercury. Consult your local municipality or your dealer about correct disposal of used

lamp units.

Attention

zzDo not use other than designated lamp units.

zzThe part numbers of accessories and separately sold components are subject to change without notice.

JJWhen to replace the lamp unit

The lamp unit is a consumable component. Brightness decreases according to duration of usage, so periodical replacement of the lamp unit is necessary.

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and <LAMP> indicator lights orange. Replace the lamp with a new one promptly.

 

On screen

LAMP indicator

Lamp runtime

Lamp replacement icon

 

 

 

 

The message is displayed for 10 seconds. If

Over 3 000 hours *

you press any button within the 10 seconds, the

message disappears.

 

 

 

Lights in orange (even in

 

 

 

If the power is turned on without replacing the lamp, stand-by mode).

Over 3 200 hours *

the power automatically turns off after approximately

ten minutes to prevent the malfunction of the

 

 

projector.

*3 200 hours of use is a rough guideline, but is not a guarantee. The lamp runtime differs depending on the

setting of "Lamp power" menu.

Note

zzThe Lamp replacement icon will not appear when the [Display] function is set to [Off] (Æpage 64), or during "Freeze" (Æpage 44).

96 - ENGLISH