When the TEMP indicator and the LAMP indicator are illuminated
There are two indicators on the control panel of the projector which give information about the operating condition of the projector. These indicators illuminate or flash to warn you about problems that have occurred inside the projector, so if you notice that one of the indicators is on, turn off the power and check the table below for the cause of the problem.
LAMP indicator
TEMP indicator
| TEMP indicator |
|
| |
|
|
|
|
|
Indicator | Illuminated (red) | Flashing (red) |
|
|
display | (Lamp unit on) | (Lamp unit off) |
|
|
|
|
|
|
|
| The surrounding temperature or | The surrounding temperature or |
|
|
| the temperature inside the | the temperature inside the |
|
|
Problem | projector has become unusually | projector has become |
|
|
high. | dangerously high, causing the |
|
| |
|
| lamp unit to automatically shut |
| maintenance |
|
| off. |
| |
|
|
|
| |
|
|
|
|
|
Possible | B The ventilation holes may be covered. |
|
| |
cause | B The ambient temperature in the place of use may be too high. |
|
| |
B The air filter may be blocked. |
|
|
| |
|
|
|
| |
|
|
|
| and |
| B Uncover the ventilation holes. |
|
| |
|
|
|
| |
| B Set up the projector in a place where the temperature is |
| Care | |
| between 0 °C (32 °F) and 40 °C (104 °F) and the humidity is |
| ||
|
|
| ||
| between 20% and 80% (with no condensation). [If you set the |
|
| |
Remedy | “HIGHLAND” to “ON” (page 52), set up the projector in a place |
|
| |
where the temperature is between 0 °C (32 °F) and 35 °C |
|
| ||
|
|
| ||
| (95 °F) and the humidity is between 20% and 80% (with no |
|
| |
| condensation).] |
|
|
|
| B Disconnect the mains lead by following the procedure on page |
|
| |
| 28, and then clean the air filter. (Refer to page 59.) |
|
| |
|
|
|
|
|
