Picture
condition
Operation Press the F or Hbutton.
Picture
condition
Operation Press the G or Ibutton.
NOTE:
BVertical keystone distortion can be corrected to ±30° of the angle of tilt. However, the greater the correction amount, the more the picture quality will deteriorate, and the harder it will become to achieve a good level of focus. To obtain the best picture quality, set up the projector and screen in such a way that the amount of keystone correction required is as minimal as possible.
BThe picture size will also change when correction of keystone distortion is carried out.
BThe ratio of length and width of an image may become incorrect depending on the amount of the keystone correction.
BKeystone distortion of the on- screen display will not be corrected.
BYou can correct the keystone distortion manually when “REALTIME KEYSTONE” is set to “ON”. However, when you turn on the power, the amount of correction will be reset and “REALTIME KEYSTONE” will function again if the tilt is different from the last time you used the projector. If you correct the keystone distortion manually when “REALTIME KEYSTONE” is set to “OFF”, the amount of correction
will be stored by the projector even after the power is turned off.
POSITION
Moves the picture position.
Press the ENTER button to display the “POSITION” screen.
Press the I or H button to move the picture horizontally.
Press the F or G button to move the picture vertically.
DOT CLOCK |
| ||
(RGB only) |
| ||
Periodic striped pattern interference |
| ||
(noise) may occur when a striped |
| ||
pattern such as the one below is | settings | ||
projected. If this happens, press the | |||
| |||
I or H button to adjust so that any |
| ||
such noise is minimised. | Adjustments and | ||
|
| ||
|
| ||
CLOCK PHASE | |||
(RGB/YPBPR only) |
| ||
| |||
Adjust the “DOT CLOCK” setting |
| ||
first before carrying out this |
| ||
adjustment. Press the I or H |
| ||
button to adjust so that the noise |
| ||
level is least noticeable. |
| ||
NOTE:
BIf signals with a dot clock frequency of 100 MHz or higher are being input, interference may not be completely eliminated when the “DOT
