Switching the projector on/off
Basic Operation
22 - ENGLISH
Switching off the projector
When operating the projector, check the status of the POWER indicator. (Æpage 20)
INPUT SELECT
RELEASE
POWER indicator
POWER LOCK indicator
(1), (2)

Press the POWER button.1 )

The conrmation screen will be displayed.
Without any operation for 10 seconds or press any button other than the
zPOWER button, the conrmation
screen will go off and return to the projection.

Press the POWER button again.2 )

The lamp goes off, the operational sound (beep) sounds, and projection stops.
The cooling fan continues its rotation and
zPOWER indicator lights in orange. Wait until the POWER LOCK
indicator and POWER indicator turn into red.
If
zSTANDBY MODE is set to NORMAL, the POWER indicator ashes in red. (Æpage 40)
You can set to
zON or OFF the beeping sound that occurs when the POWER button is in operation in
AUDIO SETTING.
(Æpage 41)

After the POWER LOCK indicator and POWER indicator light in red, disconnect the 3 )

power plug from the wall outlet. (Æpage 19)

For urgency, you may disconnect the power plug immediately since the
zDIRECT POWER OFF function is
installed.
Remarks
Conrm that
zCONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER
(when
operating with the remote control) under
CONTROL DEVICE SETUP
in the
SECURITY
menu is set to
ENABLE
.
(Æpage 44)
You can switch off the power by pressing the
zPOWER button for 0.5 seconds or more.