Projecting an image

Basic Operation
ENGLISH - 23
Projecting an image
Conrm the connections of the peripheral devices (Æpage 17, 18) and power cord (Æpage 19). Switch on the
power (Æpage 21) and the projector starts projecting. Select the input signal and adjust the image.

Selecting the input signal

1 ) Switch on the connected devices.

When playing a connected DVD player, if SIGNAL
SEARCH in the DISPLAY OPTION menu is set
to ON, the input signal is detected and projected
automatically when the projector is switched on.
(Æpage 37)
Set the
zINPUT GUIDE under the ON-SCREEN
DISPLAY in the DISPLAY OPTION menu to
DETAILED. If the projector cannot detect any
input signal, the Computer connection guidance
will display. (Æpage 36)

2 ) Select an input signal.

The image selected with the INPUT SELECT
button is projected. (Æpage 24)
Note
Change the setting of the
zPICTURE menu
according to the connected device and DVD, video
tape, etc., to be played. (Æpage 31)
Conrm the aspect ratio of the screen and image.
z
Select the optimum aspect ratio. (Æpage 33)

Positioning the image

When setting up the projector for the rst time or setting up at a new place, you must perform the following operations.

1 ) Adjust the vertical angle of the projector.

Place the projector at the right angle from the screen.
z
Press the adjuster buttons and adjust the vertical projection angle. Then, adjust the projected image to the
z
center of the screen.

Adjust the projection size and focus.2 )

Remove the Zoom-Focus ring cover
z(Æpage 12) and turn the zoom and focus rings to adjust the projected
image. After adjusting, be sure to install the Zoom-Focus ring cover to protect from dust.
Zoom ring
(ZOOM)
Focus ring
(FOCUS)
Remarks
When you adjust the zoom after adjusting the focus, you may need to adjust the focus of the image again.
z
If keystone distortion occurs, see “KEYSTONE”.
z(Æpage 32)