PICTURE menu
Settings
ENGLISH - 31
DAYLIGHT VIEW
You can keep the projected image bright and vivid
even in well-lit rooms where the ambient light sources
cannot be controlled, such as when a door opens or
when window coverings fail to block out sunlight.
Change setting Change setting
AUTO ON OFF
AUTO Automatic adjustment
ON Active
OFF Deactive
Remarks
Do not cover the Ambient Luminance Sensor (
zALS)
of the projector. The AUTO mode may not operate
normally.
AUTO
z is not available when INSTALLATION in
PROJECTOR SETUP menu is set to REAR/DESK
or REAR/CEILING.
STILL MODE
You can reduce the vertical icker when projecting a
still image.
(Available with signals of S-VIDEO/VIDEO only)
Change setting Change setting
OFF Deactive
ON Active
Note
You must set to
zOFF when projecting a moving
image.
NOISE REDUCTION
You can switch the automatic noise reduction system
on/off.
(Available with signals of S-VIDEO/VIDEO only)
Change setting Change setting
OFF No noise reduction
ON Automatic noise reduction
Note
NOISE REDUCTION
z
is set active when the selected
input signal has less noise. Applying noise reduction
may affect the image quality, if so, set to
OFF
.
TV-SYSTEM
When the video signal is changed, the setting
switches automatically. You can switch the setting
manually to match the video data.
(Available with signals of S-VIDEO/VIDEO only)
Change setting Change setting
AUTO NTSC NTSC4.43
SECAM PAL-N PAL-M PAL
Note
AUTO
z mode is selected by default.
When the projector is not working properly in
zAUTO
mode, change the setting according to each TV
system type.
Remarks
AUTO
z
setting will automatically select the compatible
signal from
NTSC/NTSC 4.43/PAL/PAL60/PAL-M/
PAL-N/SECAM
.
RGB/YPBPR
AUTO mode is selected by default. If the image is not
projected normally in the AUTO mode, select RGB or
YPBPR according to the input signal.
The function becomes effective only when certain
signals below are input.
(VGA60, 480i, 576i, 480p, 576p, 1 080/60i, 1 080/50i,
720/60p, 720/50p)
Select the signals to be input to the COMPUTER1
and COMPUTER2 IN terminal.
Change setting Change setting
AUTO Automatic adjustment
RGB For RGB signals
YPBPRFor YPBPR signals