Panasonic PV-DV702 Copying from Digital Equipment dubbing, Recording Palmcorder, Pause 6STOP 4REC

Editing Features

Copying from Digital

Equipment (dubbing)

High quality digital-to-digital copying can be accomplished if both Palmcorders incorporate the DV Input/Output (i.LINK) Connector (DV Interface cable (i.LINK) is not supplied).

Before you begin

•Connect both Palmcorders to their power sources.

•Connect the two Palmcorders using the DV Interface cable (i.LINK)

(4-pin to 4-pin).

•Turn both Palmcorders ON.

Source (Playing)

Palmcorder

DV Input/Output

(i.LINK) Connector

Recording

Palmcorder

DV Interface Cable (i.LINK) (optional)

3, 4, 5 3, 4PLAY

PAUSE

6STOP

4REC

1 Insert a pre-recorded tape into the

source (playing) Palmcorder, and set

POWER to VCR.

2 Insert a blank tape with the record tab closed into the target (recording) Palmcorder and set POWER to VCR.

3 Press (PLAY) on the source Palmcorder. When the tape reaches the point from which you want to start dubbing, press (PAUSE).

4 Hold down REC and press (PLAY) on the target (recording) Palmcorder. Press (PAUSE) to pause the tape at the starting point of the dub.

5 Simultaneously, press (PAUSE) on both units to begin dubbing.

6 Press (STOP) on the recording unit, and then press (STOP) on the playing unit to end dubbing.

Note

•When two Palmcorders are used for dubbing, it is recommended that the Remote Control VCR1 or VCR2 setting be used to avoid improper-operation.

Editing Features

3, 4, 5	4REC
PAUSE
6STOP	3, 4	CAUTION:
	PLAY

Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.

47