
The radio
Playing back
Manual tuning
1Select “FM” or “AM”.
2Select “MANUAL”.
MANUAL PRESET
3Select the frequency of the desired station.
4Adjust the volume.
•Press and hold [u 2/REW] or [i 1/FF] until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found.
•“STEREO” is displayed when a stereo FM broadcast is being received.
nIf noise is excessive in FM
Press and hold [PLAY MODE,
To cancel, press and hold [PLAY MODE,
The mode also cancels when you change the frequency.
nFM frequency step (main unit only)
You can change the frequency step (0.2 MHz or 0.1 MHz).
1.Select “FM”.
2.Press and hold [TUNER/AUX] on the main unit.
After a few seconds, “FM” starts flashing on the display. Continue to hold the button down. The minimum frequency changes and the step is changed.
•To return to the original step, repeat the above steps.
•Any preset stations are cleared by this procedure. Preset them again.
Preset tuning
Preset channels to make selection simpler. Up to 15 stations can each be preset in the FM and AM bands.
Automatic presetting
1Tune to the frequency where presetting is to begin.
(⇒ see above)
2Press and hold.
•“AUTO MEMORY” starts flashing.
•The tuner presets the stations it can receive into the channels in ascending order. When finished, “SET OK” appears and the last station to be preset is played.
Manual presetting
1Tune to the desired station. (⇒ see above)
2Press.
“PGM” appears.
3Within 10 seconds:
Select the channel.
The station occupying a channel is erased if another station is preset in that channel.
RQT8046
Selecting channels
1Press [TUNER/AUX] to select “FM” or “AM”.
2Press [PLAY MODE,
3Press the numbered buttons or [u2/REW] or [i1/FF] to select the channel.
22