Panasonic ST50P Maintenance, First, remove the mains plug from the socket outlet, Mains plug

Other

Problem	Causes / Actions
The TV does not switch on	●Check the mains lead is plugged into the TV and the socket outlet.
The TV goes into Standby	●Auto power standby function is activated. (p. 13)
mode	●The TV enters Standby mode about 30 minutes after broadcasting ends.
	●Are the batteries installed correctly? (p. 8)
	●Has the TV been switched on?
The remote control does	●The batteries may be running low. Replace them.
	●Point the remote control directly at the TV’s remote control signal receiver
not work or is intermittent
	(within about 7 m and a 30 degree angle of the signal receiver).
	●Situate the TV away from sunshine or other sources of bright light not to shine
	on the TV’s remote control signal receiver.
Parts of the TV become	●Even when the temperature of parts of the front, top and rear panels has risen,
	these temperature rises do not cause any problems in terms of performance or
hot
	quality.
Permanently lit spots on	●Due to production process involved in this technology this may result in some
screen	pixels which are permanently lit or unlit. This is not a malfunction.
Overcurrent error	●The connected USB device might cause this error. Remove the device and turn
	the TV off with Mains power On / Off switch, then turn it on again.
message appears
	●Check foreign objects are not inside the USB port.
	●Follow the message’s instructions.
An error message appears	●If the problem persists, contact your local Panasonic dealer or the authorised
	service centre.

Maintenance

First, remove the mains plug from the socket outlet.

Display panel, Cabinet, Pedestal

Regular care:	For stubborn dirt:
Gently wipe the surface of the display panel,	First clean the dust on the surface. Dampen a soft cloth with
cabinet, or pedestal by using a soft cloth to clean the	clean water or diluted neutral detergent (1 part detergent to 100
dirt or fingerprints.	parts water). Wring the cloth and wipe the surface. Finally, wipe
	away all the moisture.

Caution

●Do not use a hard cloth or rub the surface too hard, otherwise this may cause scratches on the surface.

●Take care not to subject the TV’s surfaces to water or detergent. Liquid inside the TV could lead to product failure.

●Take care not to subject the surfaces to insect repellent, solvent, thinner or other volatile substances. This may degrade surface quality or cause peeling of the paint.

●The surface of the display panel is specially treated and may be easily damaged. Take care not to tap or scratch the surface with your fingernail or other hard objects.

●Do not allow the cabinet and pedestal to make contact with a rubber or PVC substance for a long time. This may degrade surface quality.

Mains plug

Wipe the mains plug with a dry cloth at regular intervals. Moisture and dust may lead to fire or electrical shock.

FAQs Maintenance

93