Panasonic VDR-D150GN 104, Disc Eject lever, Recording does not start Used for recording. l

LSQT1052(ENG).book 104 ページ ２００５年１２月２１日 水曜日 午後６時５０分

Troubleshooting

Problem

Check points

The DISC EJECT lever	≥ The disc cover will not open unless the unit is powered.
does not work.	# Connect a charged battery or AC adaptor.
A function indication
such as mode indication,
remaining time	≥ If you set [SETUP]>[DISPLAY]>[OFF], indications other
indication, or elapsed	than warnings and date indications disappear.
time indication is not
shown.
	≥ Is the DVD-RAM or the DVD-RW (VR format) write-
	protected?
	# Release the protection. (l 85) If the DVD-RAM or DVD-RW
	(VR format) was protected on another device, release the
	protection on the same device.
	≥ Has the DVD-RW (Video format) or DVD-R been finalized?
	# After finalizing, the discs become play-only and cannot
	record. If you un-finalize a DVD-RW (Video format), it can be
Recording does not start	used for recording. (l 84)
	≥ Has the SD card’s write protect switch been set to LOCK?
although power is	# No recording is possible while the write protect switch is set
supplied to this unit and	to LOCK. (l 16)
the disc or card is	≥ Is the memory of the disc or card full?
correctly inserted.	# If the disc or card has no more available memory, free up
	some memory by deleting unnecessary scenes (l 64, 77) or
	use a new disc or card.
	≥ Is the unit set to the disc recording mode or card recording
	mode?
	# No recording is possible unless the mode dial is at	or
	.
	≥ Is the disc cover open?
	# If the cover is open, this unit may not operate normally. Close
	the disc cover.
Recording starts but	≥ Is the disc scratched or dirty?
stops immediately.	# Clean the disc. (l 17)
The playback picture	≥ The unit is hot. Follow the messages on the display.
	To use the unit again, turn the unit off and leave it for a
breaks up for a moment.	while.

Others

104

LSQT1052