Panasonic VDR-D150GN operating instructions Screen indications in the disc recording mode

LSQT1052(ENG).book 39 ページ ２００５年１２月２１日 水曜日 午後６時５０分

Recording motion pictures

≥The maximum number of scenes on a disc

(per side): 999 (Even if there is remaining capacity for recording (on a disc), you may not be able to record 999 scenes.)

≥While “WRITING THE INFORMATION ON THE DISC.” is displayed, do not disconnect the AC cable or remove the battery as doing so may make the disc unusable.

≥Sound is recorded in Dolby Digital from the internal stereo microphone on the front of the unit. Take care not to block this microphone.

≥Each time the unit enters the recording pause mode, the counter display will be reset to “0h00m00s”.

Screen indications in the disc recording mode

ARemaining time left for recording

(When the remaining time is less than 1 minute, [R 0h00m]		SP 0h00m10s
	A	R 0h02m
flashes red.)
	B
B Recording mode
C Recording time elapsed	C

≥While motion picture recording is in progress, do not disconnect the battery or AC adaptor. If you do, a repair disc message may be displayed when the power is turned back on. (l 100, About recovery)

Immediately after recording finishes the ACCESS/PC lamp lights. While it lights, the disc is rotating and disc information is being recorded. If you run while holding the unit or swing it, the recorded images may be distorted so do not strongly shake or cause impact to it.

Recording

39

LSQT1052