Panasonic VDR-D150GN operating instructions 100, About recovery

LSQT1052(ENG).book 100 ページ ２００５年１２月２１日 水曜日 午後６時５０分

Indications

CHECK CARD.	This card is not compatible or it cannot be recognized by the
	unit.
CARD LOCKED.	The write protection switch on the SD Memory Card is set to
	LOCK. (l 16)
CARD FULL.	The SD card is full so no further data can be recorded. Delete
	unnecessary files (l 77) or insert a new SD card.
PUSH THE RESET	An irregularity in the unit has been detected. Press the RESET
SWITCH.	button to restart the unit. (l 106)
CHANGE TO MANUAL
MODE.	You are attempting to use a function that cannot be used
CANCEL NIGHT VIEW	simultaneously.
MODE
CHANGE MODE TO USE	The USB cable is connected in the recording mode.
USB.
DISCONNECT USB	The unit cannot correctly establish the connection to the
	computer or printer. Disconnect and then reconnect the USB
CABLE.
	cable or check the [USB FUNCTION] setting on this unit.

About recovery

It is possible that the system cannot complete writing of a file normally when, for example, power is turned off for some reason during recording or editing.

If faulty management information is found when a disc is accessed, the following message may appear. Be sure to follow the messages. (Repairing may take time depending on the error.)

DISC ERROR HAS OCCURRED. REPAIR DISC NOW?

≥When you repair the disc, use a battery with sufficient battery power or the AC adaptor.

≥Depending on the condition of the data, it may not be possible to completely repair the data.

≥If the disc is removed without it being repaired, you will no longer be able to playback the scenes recorded before the power went off.

≥Do not repair a disc that has been recorded on another device. This may cause the loss of data or the disc.

Others

100

LSQT1052