**BACK-FOCUS SETUP**
ABFPUSH SW MANUAL-ADJ
C/L← →B/W AUTO
SETUP-SW LOCK OFF
NEARFAR
.........I.........
INDICATOR XXXX RET TOP END

Image stabilization may not function where there is excessive camera movement or when the scene is low light or low contrast objects.

16. LENS

When using WV-CW484F or WV-CW484S (with a Panasonic x2 varifocal lens), select

PANASONIC.

When using WV-CW484FK or WV-CW484SK (with a lens other than Panasonic), select

OTHER.

17. Back-focus Setting (BACK-FOCUS SETUP)

If applicable, perform adjustment of the lens

focus as described in p. 26 "Before Back-focus Adjustment" on the INSTALLATION page.

Perform adjustment of the back focus (flange- back: the gap between the lens and focal plane) remotely on this menu using a system controller. After installation, you can perform this adjustment when defocus arises that may be caused by long-term use, environmental changes, etc.

Important: Do not use the ABF function for continuous or repetitive purposes (ex. autofocus etc.). This function is to be used to correct defocus caused by switching between color and black - and - white when/after installing the camera.

1.Select BACK-FOCUS on the WV-CW484 TOP menu and press SET.

The BACK-FOCUS SETUP menu opens.

2.Select ABF and press SET.

Adjustment is automatically performed.

Notes:

Performing ABF will function to obtain the best focus around the center areas in a scene.

Performing ABF is available only when OFF, X2 AUTO, or X2 FIX is selected for SENS UP.

3.Select MANUAL-ADJ and press SET if manual adjustment is required. The manual back-focus adjustment screen will open.

Use the [LEFT] and [RIGHT] buttons for 2 seconds or more to move the "I" cursor and obtain a proper focus.

Refer to the 4-digit number on the second bottom line. The larger the number is, the bet- ter the focus will be.

Select RET and press SET to go back to the menu setup.

41

Page 41
Image 41
Panasonic WV-CW484F operating instructions Lens, Back-focus Setting BACK-FOCUS Setup