AWC Setting
1.Select AWC and press the [L] button.
→AWC will change to AWC → PUSH SW.
2.Press SET.
→PUSH SW will be highlighted while the AWC setting is performed.
Note: If the white balance is not set, PUSH SW is being highlighted. 3 . Press the [R] button.
Manual Fine Adjustment
Perform fine adjustment as necessary. |
| **ATW1** |
|
| ||
|
|
|
|
| ||
1. Select WHITE BAL and press SET. | R |
|
| 128 | ||
...I... | ||||||
→ Fine adjustment menu of ATW or AWC will |
| - | + | |||
B | ...I...128 | |||||
open. | ||||||
| - | + | ||||
|
| |||||
2.Adjust finely R (Red) and B (Blue) gain by moving the "I" cursor.
RET TOP END
8. Motion Detection Setting (MOTION DET)
When a series of changes in pictures is detected, the camera outputs an alarm to the external device such as a disk recorder. The recorder will start recording the pictures.
1.Select a mode for MOTION DET on the CAMERA SETUP menu. The default setting is OFF.
OFF: Disables the alarm output.
MODE1↓: Outputs alarm when a series of
motions is detected.
MODE2: Outputs alarm when a series of scene changes is detected.
→ The MODE 1 menu opens when you select MODE1 and press SET.
2.Adjust for LEVEL to optimize the sensitivity of detection.
3.Select a dwell time. The default is 2S. Available time (second): 2, 5, 10, 30
The next detection will be performed after the set time elapses.
...I..128
-+
2S
OFF
4. Select MASK SET and press SET.
→ A
•Specify
•Hold down SET for 2 seconds to return to the MOTION DET menu.
Note: Perform the setting of mask area after STABILIZER in the CAMERA SETUP menu is set to OFF.
36
