Initializing the Camera Menu | Panasonic WV-NW470S, WV-NW474SE

INITIALIZING

You can reset the following data back to the factory default settings.

Camera Setup

Setup Menu (PC oriented) HTML files

■Initializing the Camera Menu

•Move the cursor to CAMERA RESET.

•Hold down [Left], [Right], and [SET] buttons simulta- neously for 2 seconds on the camera, or click the All Reset button on your computer display.

■Initializing the Setup Menu

•In the power-on state, press the [Up] and [Down] buttons simultaneously while holding down the but- ton A.

Hold down the button A for 15 seconds. It will take about 10 seconds to complete the initializing. Be sure to continue supplying power to the camera while initializing.

Notes:

•Clock calibration is required even after initializing the setup menu.

•Try again if the previous initializing failed.

■Initializing HTML Files

•In the power-on state, press the side panel buttons, [Up] and [Down] simultaneously while holding down the button B.

Hold down the button B for 15 seconds. It will take about 10 seconds to complete the initializing. Be sure to continue supplying power to the camera while initializing.

Notes:

•Never press both the buttons A and B at a time.

•Try again if the previous initializing failed.

-30-

Image 30

Panasonic WV-NW470S, WV-NW474SE Initializing the Camera Menu, Initializing the Setup Menu, Initializing Html Files

Contents

WV-NW474SE Risk of Electric Shock Do not Open Contents System Requirements FeaturesPreface Trademarks Document Convention Never face the camera towards the sun PrecautionsHandle the camera with care Do not aim the camera at the same object for a long time Major Operating Controls & Their Functions @4Power cable 8DIP switch@3Control connector @2Video output connector Installation space InstallationInstallation Plans & Preparations Procurement Mounting the Camera Optional Heater Unit Cable length and wire gauge 24 V AC Type Power ConnectionWire colours & functions AC Type Connections Video Output Connection Image AdjustmentControl Connector Network Port Connection Waterproof Process Connection to Intranet Type Network Connection TypesDirect Connection to PC Type Connection to Internet Type Network Setup of Your PC Preparations for Network Connections Network Setup of the Camera Using Panasonic IP Setup Software Dhcp DNS DdnsPage Camera Setup Menus Prior to Camera SetupButtons Used for Setup ALL Reset button ¡From the Camera Setup Menu Tree Camera Setup Menu CAM Setting ProceduresSetup Selection Camera Identification Camera ID Setting To edit the Camera ID Light Control Setting ALCCommand Usage To replace a specific character in the Camera ID Gain Control Setting AGC on DNR-L, DNR-H/OFF Shutter Speed Setting ShutterElectronic Sensitivity Enhancement Sens UP Synchronization Setting Sync White Balance Setting White BALATW1 Auto-Tracing White Balance Manual Fine Adjustment for AWC ATW Motion Detector Setting Motion DETAutomatic White Balance Control Mode AWC Push SW Menu/DIP SW Selection Special Menu Special To reset to the factory settings Camera Reset 10-6. BW Network Setup Network Setup Http Port Number Initializing the Camera Menu Initializing the Setup MenuInitializing Initializing Html Files Troubleshooting Prevention of Blooming and Smear SpecificationsTCP/IP, HTTP, FTP, SMTP, DNS, DDNS, DHCP, ARP, BOOTP, NTP Network Section General Standard AccessoriesOptional Accessories WV-NW474SE Appendix Optional Heater Unit WV-CW3HE 在日本印刷