MAJOR OPERATING CONTROLS & THEIR FUNCTIONS
u i
A |
q w
!0
!1
LED ON |
|
|
| B | o |
|
| |
LED OFF |
| !2 |
LINK RCV |
|
|
LEFT |
| !3 |
RIGHT |
| !4 |
UP |
| !5 |
DOWN |
| !6 |
|
|
A LED ON 
B
LINKRCV 
LEDOFF
LEFT 
RIGHT
UP 
DOWN
Transport Protection Screws (Red)
!8
!7 |
SET |
!9 |
SET
y
t r e
qTilting lock screw Fixes the tilting position.
wPanning table
Adjusts the panning angle of the camera.
eAzimuth adjuster
Adjusts the azimuth angle to level the image.
rPan lock screw
Fixes the panning position.
tZoom lock lever
Fixes the zoom position after adjustment.
yFocus lock lever
Fixes the focus position after adjustment.
uOptional heater connector
When an optional heater unit is installed in the cam- era, the harness exiting from the unit will be con- nected to this.
iReset button (A)
Holding down the Up and Down buttons simultane- ous for 15 seconds in the
Note: Never press both reset buttons A and B at the same time.
oReset button (B)
!0LED switch
ON: Enables the LINK and RCV LEDs to | ON |
| |
indicate the communication status. |
|
OFF: Disables the status indication. |
|
Note: Normally set the switch to OFF. Set it | OFF |
to ON only when you check the communication status. Failure to do so may cause disturbance to the camera image, or light leakage to the outside of the camera in dark places.
!1Link indicator (LINK)
Lights up when establishing communications via the network if the LED switch is set to ON.
!2Receive indicator (RCV)
Lights up when receiving data via the network if the LED switch is set to ON.
!3Left button (Left)
Moves the cursor to the left, selects the mode, and adjusts some levels.
!4Right button (Right)
Moves the cursor to the right, selects the mode, and adjusts some levels.
!5Up button (Up)
Moves the cursor upward and selects items in the menu setup.
!6Down button (Down)
Holding down the Up and Down buttons simultane- ously for 15 seconds in the
Moves the cursor downward and selects items in the menu setup.
