Using the mount bracket (accessory) SW458
Note:
•When the camera is mounted on the ceiling or wall with a hole for cable running, or the camera is mounted using open wiring, the mount bracket (accessory) is used.
IMPORTANT:
•If open wiring is conducted, be sure to use conduits and run the cables inside the tubes to protect the
cables from direct sunlight.
• Installation work shall be such that there is no exposure to water into the architecture through the conduits hav- ing been joined.
Conduit
z Loosen two fixing screws on both ends of the base cover (accessory) by using the bit for tam- perproof screw (accessory), and remove the base cover (accessory).
When using a conduit, use a hexagon wrench (ISO 2936, width across flats S=5 mm {5/64 inches}) or other tool and also remove the cap for the female thread for the conduit.
Note:
•The female thread for the conduit is compliant with ANSI NPSM (parallel pipe threads)
3/4 inch or G3/4 of ISO
Base cover xing screws
Mount bracket (accessory)
Base cover (accessory)
Cap for the female thread for the conduit
20
