IMPORTANT:
•Input and output of the External I/O terminal 2 and 3 can be switched by configuring the setting. “Off” is selected by default. It is possible to determine whether or not to receive input from External I/O terminal 2 and 3 (ALARM IN2, 3) by selecting “Off”, “Alarm input”, “Alarm output” or “AUX output” for “Terminal 2” or “Terminal 3” on the [Alarm] tab of the “Alarm” page. Refer to the Operating Instructions on the provided
•When using the External I/O terminals as the output terminals, ensure they do not cause signal collision with external signals.
•In order for the External I/O terminal to detect alarm inputs when the terminal status is changed from Open to Close (On) or from Close to Open (Off), about 100 ms or more is needed. Because alarms cannot be detected for about 5 seconds after a detection is made, alarm inputs received within about 5 seconds after an alarm is detected are not detected.
vConnect a LAN cable (category 5 or better, straight, STP*) to the network connector.
*E model only
b Connect the power cable.
IMPORTANT:
• The 12 V DC power supply shall be insulated from the commercial AC power.
•When using 12 V DC power supply*1
Connect the output cable of the AC adaptor to the 2P power cable (accessory).
•When using PoE (IEEE802.3af compliant)
Connect a LAN cable (category 5 or better, straight, STP*2) between a PoE device (such as a hub) and the network connector of the camera.
*1 ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY or LIMITED POWER SOURCE. *2 E model only
IMPORTANT:
•Use all 4 pairs (8 pins) of the LAN cable.
•The maximum cable length is 100 m {328 feet}.
•Make sure that the PoE device in use is compliant with IEEE802.3af standard.
•When connecting both the 12 V DC power supply and the PoE device for power supply,
12 V DC will be used for power supply. Depending on the PoE device used, the power supply lamp may not light and the network connections may not be possible. In this case, disable the PoE device setting, and refer to the operating instructions of the PoE device in use.
•When the LAN cable is disconnected once, reconnect the cable after about 2 seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE device.
27
