Panduit DPOE24U1XY, DPOE24S1XY, DPOE12U1XY manual Powering Up the DPoE Power Patch Panel

PANDUIT® DPoE™ Power Patch Panel User’s Guide		Issue 2.2
	Part Number: PN378A

WARNING:

The power supply connections are polarized.

The DPoE™ Power Panel will not function if power is wired improperly.

For Maximum power the overall length of the wire between the power supply and the DPoE™ Power Panel must not exceed 35 feet.

NOTE:

The included power harness has two wires for the A-feed power only (pins 1 & 2). The DPoE™ Power Patch Panel supports an optional redundant B-feed power option, but the terminals and wire leads are not attached to the power harness.

Contact PANDUIT Technical Support for more information about connecting the redundant B-Feed Power.

14. Lightly tug on the butt spliced connections to verify that the butt splices are secure.

Powering Up the DPoE™ Power Patch Panel

15.Plug the connector into the back of the DPoE™ Patch Panel.

16.Once power is applied to the unit, the DPoE™ Power Patch Panel will go through its power up sequence. The following table describes the behavior of the unit as viewed from the front and the back.

14