Panduit DPOE24S1X, DPOE24U1X manual Basic Troubleshooting, DPoE Power Patch Panel Power Up Sequence

PANDUIT® DPoE™ Power Patch Panel User’s Guide	Issue 2.2
	Part Number: PN378A

Table 6: DPoE™ Power Patch Panel Power Up Sequence

Behavior as viewed from the back of the unit

Both network status LEDs will light amber for two seconds

If there is no cable connected to the IN management port (Step 5 above), both network status LEDs will turn off.

If the DPoE™ Power Patch Panel is configured for DHCP address assignment (default factory setting), the network status LED above the IN management port will stay amber and the network status LED above the OUT management port will turn off. This indicates that the panel is actively requesting address information from the network. Once this information is received (this could take up to a minute), the network status LED above the IN management port will turn on or start flashing green as data is transmitted and received.

If the panel were set to static IP addressing rather than DHCP, the network status LED above the IN management port will immediately turn green.

Behavior as viewed from the front of the unit

The panel status Light-Emitting Diode (LED) will light red for about 10 seconds. After that, a LED test sequence of the port status LEDs will take place, lighting each port status LED amber. It will appear as if the port status LED is “walking” from port 1 through port 24.

If the Patch Panel is configured for Dynamic Host Control Protocol (DHCP) address assignment (default configuration) and a cable is NOT connected to the IN management port on the rear of the panel, the panel status LED will turn green.

If the DPoE™ Power Patch Panel is configured for DHCP address assignment (default factory setting), the panel status LED will flash amber. This indicates that the panel is actively requesting address information from the network. Once this information is received (this could take up to a minute), the panel status LED will flash green. (See page 5, Figure 1: DPoE™ Power Patch Panel (Front View) and page 6, Figure 2: DPoE™ Power Patch Panel (Rear View) for a graphical view of the LEDs on the DPoE™ Power Patch Panel.)

If the panel were set to static IP addressing rather than DHCP, the panel status LED will flash green and continue flashing as long as power is applied to the unit.

Basic Troubleshooting

Use the following guide to help resolve problems installing the DPoE™ Power Patch Panel. If the problem persists, contact PANDUIT Corp Technical Support or a local sales representative. (See page 9, Table 3: PANDUIT Corporation Contact Information, for contact information.)

15