Panduit LS3E manual Make sure ribbon is advancing

Unexpected printing results.	Battery pack is fully drained.	Charge battery pack, if “LOW
		BATTERY” warning message
		was previously received.
	Printhead is not moving freely,	Make sure ribbon is advancing
	causing text to be compressed	freely.
	together or printed on edge of
	label.	Make sure no labels are stuck
		in the printer.
		If required, lubricate
		printhead shafts (see below
		for more information).
Printhead does not slide freely	Printhead shafts need to be	Carefully apply a thin film of oil
or fully.	lubricated.	(Tuffoil Lubit-8, or equivalent)
		to the 2 printhead shafts. Tuffoil
		Lubit-8 is manufactured by:
		Fluoramics, Inc.
		18 Industrial Avenue
		Mahwah, NJ 07430
	Battery pack is fully drained.	Charge battery pack, if “LOW
		BATTERY” warning message
		was previously received.
Ribbon is not advancing	Ribbon is not loaded correctly.	Load ribbon properly between
properly.		the printhead and print shield.
		Carefully apply a small amount
	Ribbon drive pin needs to be	of oil to the drive pin (Tuffoil
	lubricated.	Lubit-8, or equivalent).
Code vs. Size error message.	Printer width sensor detects	Verify label code and enter
		correct label code, if incorrect.
	label width different than that	Close printer door.
	defined by the label code.
		Press any key to clear error
		message, and ignore.
Character does not display on	Key is stuck.	Make sure no keys are stuck in
screen when key is depressed.		the depressed position.

24