printer shuts down. The battery should then be recharged fully for 15 hours. When fully charged, the battery pack will measure 14-14.5 volts, and will power the printer all the way down to approximately 11 volts. The printer has an auto shut-off feature which will automatically turn the printer off after being idle for 5 minutes to conserve battery power.
NOTE:
“WARNING: LOW BATTERY” message is a warning and may appear with some battery life remaining. Therefore the printer can continue to be used until it shuts down.
RIBBON CARTRIDGE INSTALLATION
Open the label door of the printer by inserting your finger into the label exit slot and gently pulling up OR grasp the label compartment cover and pull up gently. Place the ribbon cartridge (Part Number LS3-RIB) in the ribbon compartment with the metal tear bar facing upward and the manual advance knob on the left (See Figure 2). Turn the manual advance knob counterclockwise while applying gentle downward pressure until the knob is positioned. Continue to turn the manual advance knob while pushing down on the screws on the metal tearbar until the ribbon cartridge snaps onto both plastic tabs on the sides of the rubber drive roller. Once installed, turn the manual advance knob counterclockwise to make sure the ribbon is loaded properly. Make sure the ribbon is between the nose of the print head and the print shield (See Figure 2).
