ParaBody GS6 manual Optional LB. ADD-ON KIT GS-6 Shroud Option only Step

FIGURE 6

37

AI

AK

AZ

AN

AJ

D

OPTIONAL 50

LB. ADD-ON KIT

GS-6 SHROUD

OPTION ONLY!

STEP 6:

•Insert two GUIDE RODS (AI) into the REAR FRAME (O) as shown on FIGURE 6. (NOTE: If theGS-6 SHROUD OPTION was purchased, place the GUIDE RODS (AI) through the BOTTOM SHROUD BRACKET (found in SHROUD OPTION box) and into the REAR FRAME (D) as shown in FIGURE 6.

•(NOTE: Lubricate GUIDE RODS (AI) with silicon or teflon spray available at most hardware stores.)

•Slide two WEIGHT STACK SPACERS (AJ), and two WEIGHT STACK CUSHIONS (AN) down over the GUIDE RODS (AI).

•Using EXTREME CARE slide all fifteen WEIGHT PLATES (NOTE: If 50-LB.ADD-ON KIT was purchased, slide twenty WEIGHT PLATES and discard the two WEIGHT STACK SPACERS (20) and refer to the 50 LB. ADD-ON Kit instructions) down over the GUIDE RODS (AI) on to the WEIGHT STACK CUSHIONS (AN). Make sure that the WEIGHT PLATES are all facing as shown.

•Slide the HEAD PLATE ASSEMBLY (AK) down over the GUIDE RODS (AI) onto the weight stack.

•Slide two SHAFT COLLARS (37) over the GUIDE RODS (AI) as shown in FIGURE 6.

•Apply WEIGHT STACK LABELS (AZ) to WEIGHT PLATES and HEAD PLATEASSEMBLY (AK) as shown in FIGURE 6. Begin with

number one at the HEAD PLATE (AK) with larger numbers in consecutive order towards bottom of weight stack.

10