ParaBody GS6 manual X 7-1/4

	26
36
	D
22
1/2 X 7-1/4” 2	AE
FIGURE 20

STEP 20:

•Insert one 3/4” X 6” SHAFT (36) into the tube on the REAR FRAME (D) as shown.

•SECURELY assemble the PRESS LOAD ARM (AE) to the REAR FRAME (D) using one 1/2 X 7-1/4” BOLT (2), one 1/2” WASHER

(22)and one 1/2” LOCK NUT (26). (Note: Tighten this connection enough to remove excess play yet allow the PRESS LOAD

ARM to rotate freely.)

D 26

22

I

1/2 X 10-1/2” 1

FIGURE 21

STEP 21:

•SECURELY assemble the PRESS ARM (I) to the REAR UPRIGHT (D) using one 1/2 X 10-1/2” BOLT (1), two 1/2” WASHERS (22) and one 1/2” LOCK NUT (26) as shown in FIGURE 21.

20