1. Network Management Specification
Table 1-98. devLastTrapString (2 of 4)
Trap
devLastTrapString
DSX Traps
dsx1LineStatusChange | "The dsx1LineStatus has changed on a dsx1 interface." |
|
|
| |
|
|
atmfM4IfAisAlarm | "AIS alarm detected." |
|
|
atmfM4IfLcdAlarm | "Loss of Cell delineation detected." |
|
|
atmfM4IfLosAlarm | "Loss of Signal detected." |
|
|
atmfM4IfLofAlarm | "Loss of Frame detected." |
|
|
atmfM4VclXConnCreated | "VCL |
|
|
atmfM4VclXConnDeleted | "VCL |
|
|
atmfM4VclXConnChanged | "VCL |
|
|
atmfM4HwFanFailAlarm | "Fan alarm - [up/down]." |
|
|
| Entity MIB Traps: |
|
|
entConfigChange | "Entity configuration changed." |
|
|
| SHDSL MIB Traps: |
|
|
hdsl2ShdslLoopAttenCrossing | " Loop attenuation threshold has been reached/exceeded for the SHDSL segment |
| endpoint." |
|
|
hdsl2ShdslSNRMarginCrossing | " SNR margin threshold has been reached/exceeded for the SHDSL segment |
| endpoint." |
|
|
hdsl2ShdslPerfESThresh | "Errored Seconds (ES) threshold has been reached/exceeded for the SHDSL |
| segment endpoint." |
|
|
hdsl2ShdslPerfSESThresh | "Severely Errored Seconds (SES) threshold has been reached/exceeded for the |
| SHDSL segment endpoint." |
|
|
hdsl2ShdslPerfCRCanomaliesThresh | "CRC anomalies threshold has been reached/exceeded for the SHDSL segment |
| endpoint." |
|
|
hdsl2ShdslPerfLOSWSThresh | "LOSW seconds threshold has been reached/exceeded for the SHDSL segment |
| endpoint." |
|
|
hdsl2ShdslPerfUASThresh | "Unavailable seconds threshold has been reached/exceeded for the SHDSL segment |
| endpoint." |
|
|
hdsl2ShdslSpanInvalidNumRepeaters | "Mismatch has been detected between the number of repeater/regenerator units |
| configured for a SHDSL line and the actual number of repeater/.regenerator |
| discovered via the EOC." |
|
|
hdsl2ShdslLoopbackFailure | "Endpoint loopback command failed for an SHDSL segment." |
|
|
hdsl2ShdslpowerBackoff | "Power Backoff status has changed for this Endpoint." |
|
|
hdsl2ShdsldeviceFault | "Device Failure status has changed for this Endpoint." |
|
|
hhdsl2ShdsldcContinuityFault | "dc Continuity Fault status has changed for this Endpoint." |
|
|
hdsl2ShdslconfigInitFailure | "Config Init Failure status has changed for this Endpoint." |
|
|
hdsl2ShdslprotocolInitFailure | "Protocol Init Failure status has changed for this Endpoint." |
|
|
June 2003 | 95 |