Paradyne installation instructions Power Up Your IPD4000E

CAUTION If a blank plate is removed from slot 2-4, it must be replaced with an interface module. DO NOT OPERATE YOUR IPD4000E WITH AN EMPTY MODULE SLOT.

1.4.2 Align the Interface Module with the Slot Module Guides

With the interface module PCB facing UP and the interface module model name, and Net to Net logo, on the RIGHT side of the module faceplate (facing towards you), align the left and right edges of the PCB with the slot module guides of the chosen slot on the IPD4000E.

Slot Module Guides

INTERFACE MODULE

1.4.3 Slide the Interface Module Firmly into the Chassis

Tighten the fastening screws on the interface module faceplate by turning them clockwise with a Phillips screwdriver. Be careful NOT TO OVER-TIGHTEN the screws.

Fastening Screws

1.5 Power Up Your IPD4000E

CAUTION Turn your DC power source(s) OFF until you have completed connection of the IPD4000E as outlined below.

IPD4000E Installation Instructions 220-0000097 rev01 Page 7 of 17