MANAGEMENT MODULE

Slot Module Guides

1.3.4 Slide the Management Module Firmly into the Chassis

Tighten the fastening screws on the management module faceplate by turning them clockwise with a Phillips screwdriver. Be careful NOT TO OVER-TIGHTEN the screws.

Fastening Screws

1.4 Install Your Interface Module(s)

Interface modules provide the subscriber connections for an IPD4000E; up to four [4] interface modules may be installed in the IPD4000E (slots 1-4). There are a variety of models available for purchase; visit http://www.nettonet.com/products for a list of available products or contact your Net to Net sales representative for further information. Any combination of interface module models may be installed in an IPD4000E as long as they are supported by the model type and version number of your management module; refer to the Release Notes for your particular management module model at http://www.nettonet.com/support/docs for compatibility information.

1.4.1 Select a Slot for Installation

Although the IPD4000E is factory shipped with Slot 1 open, interface modules may be installed in any slot, 1-4.

IPD4000E Installation Instructions 220-0000097 rev01

Page 6 of 17

Page 6
Image 6
Paradyne IPD4000E installation instructions Install Your Interface Modules