DC Terminal Blocks

1.5.3 Establish a Power Connection

DC POWER SPECIFICATIONS

-48V DC

10 Amps maximum

Although actual power draw depends upon chassis configuration, a fully loaded chassis averages around 6 Amps.

1.5.3.1 Connect Your Positive Power Lead to the Terminal Block

Using a Phillips Screwdriver, remove the upper screw from the chosen terminal block (labeled "+" on the chassis). Slide the ring terminal of your positive power lead around the shaft of the screw and re-insert the screw into the same "+" terminal from which it was removed.

Ring

POSITIVE

Terminal

POWER LEAD

 

Positive (+)

Terminal

DC POWER

TERMINAL

1.5.3.2 Connect Your Negative Power Lead to the Terminal Block

Remove the right-hand screw (labeled "-") from the same terminal block. Slide the ring terminal of your NEGATIVE lead around the shaft of the screw and re-insert the screw into the same "-" terminal from which it was removed.

IPD4000E Installation Instructions 220-0000097 rev01

Page 9 of 17

Page 9
Image 9
Paradyne IPD4000E installation instructions DC Power Specifications