![](/images/new-backgrounds/1165262/16526261x1.webp)
Model 2160 Series User Manual | 3 • Hardware installation |
|
|
Grounding the Model 2160 and connecting power
In connecting to the power source, it is important to establish a good grounding connection first, then the power connection. Do the following:
1.Assemble a ground wire using #10 AWG wire with
–The building ground rod (generally located at the site’s main service entrance)
–A sprinkler system pipe
–A
–Building structural steel
4
LINE
Grounding stud
Figure 6. Grounding stud
2.Install the grounding wire between the grounding stud (see figure 6) and the grounding source.
3.Connect the power adapter to the DC 9V port on the Model 2160, and then connect to the power source.
WARNING
WARNING
Mains Voltage: Do not open the case the when the power cord is attached. Line voltages are present within the power supply when the power cords are connected. The mains outlet that is utilized to power the device shall be within 10 feet (3 meters) of the device, shall be easily accessible, and pro- tected by a circuit breaker.
The Model 2160 is not shipped with power cables. For AC powered units, ensure that the power cable used meets all applicable standards for the coun- try in which it is to be installed, and that it is connected to a wall outlet which has earth ground.
The power supply automatically adjusts to accept an input volt- age from 100 to 240 VAC(50/60 Hz).
IMPORTANT
Installing the Model 2160 | 31 |