Pelco C3463M-B manual System Information, DIP Switch Information

System Information

SPECTRA IV

LANGUAGE

<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS> ACK ALERT*

RESET CAMERA

CYCLE CAMERA POWER REBOOT SYSTEM

EXIT

SYSTEM INFORMATION	ADDITIONAL
SERIAL #	FREE MEMORY
DOME DRIVE MODEL	LAST RESET
BACK BOX MEMORY	AZIMUTH ZERO OFFSET
SOFTWARE VERSION	MOTOR ACTIVE
BUILD	CAMERA ACTIVE
FONT VERSION	VIDEO LEVEL
COMM	CAMERA MODEL
	LANGUAGE 1
D ADDRESS	LANGUAGE 2
P ADDRESS	LANGUAGE 3
CM9500 MODE	LANGUAGE 4
32 PRESETS	LANGUAGE 5
PROTOCOL	LANGUAGE 6
PRESSURIZED*	LANGUAGE 7
<ADDITIONAL>	LANGUAGE 8
BACK	LANGUAGE 9
	LANGUAGE 10
EXIT	<DIPSWITCH INFORMATION>
	BACK
	EXIT

The System Information menu displays the dome drive model, software version, available memory, DIP switch information, and other diagnostic information.

System settings cannot be changed using this menu; this information is for reference only.

Use the following steps to display the System Information menu:

1.Use the joystick to position the cursor beside SYSTEM INFORMATION.

2.Press Iris Open. The SYSTEM INFORMATION menu opens.

DIP SWITCH INFORMATION

The DIP Switch Information menu displays the dome drive’s current DIP switch settings. This provides a way to remotely view the DIP switch settings without removing the dome drive from the back box.

DIP SWITCH INFORMATION
1 2 3 4 5 6 7 8		1 2 3 4 5 6 7 8 9 0	]
SW1[- - - - - - - -	]	SW2[- - - - - - - - - -

SW1 1-8 :

D ADDRESS 1

P ADDRESS 1

SW2 1 : 32 PRESETS. OFF

SW2 2 : CM9500 MODE. OFF

SW2 3 : COAX SPIV

SW2 4-5 : RS422 <->

SW2 6-8 : COMM. 2400.N.8.1

SW2 9 : UTC SOURCE. COAX

SW2 10 : TX/RX TERM.. OFF

PRESS IRIS OPEN TO CONTINUE

*This setting applies to Pressurized Spectra IV dome systems only.

20 C3463M-B (2/11)