Pelco VMX300 installation manual Network

Internet Protocol: Complete the following steps (refer to Figure 28):

a.Connect the wall block to an RS-422 port on the networked device. If the networked device does not have an RS-422 port, use an RS-232 to RS-422 converter.

b.Connect the IP network to the Ethernet port of the VMX300(-E); refer to IP-Based Devices on page 40 for detailed information.

c.Add the Pelco Keyboard (KBD300) driver and the keyboard to the VMX300(-E) server configuration, and select Internet Protocol as the connection type (refer to the VMX300(-E) Server Configuration Manual for detailed instructions).

d.Configure the keyboard for CM6800 ASCII mode. Configure the remaining keyboard settings to match the communication settings on the networked device (refer to the KBD300A Installation/Operation manual for instructions).

12 VAC

NETWORK	5 6	7	8
	4 3	2	1
	NETWORKED DEVICE			KBD300A
	WALL BLOCK

VMX300(-E)

SERIAL DATA

NETWORK CONNECTION

Figure 28. KBD300A: IP Connection

Configure the Keyboard DIP Switches

1.Remove the DIP switch cover plate on the rear of the keyboard. Switches 1 to 4 control the keyboard address. Switches 5, 7, and 8 control the keyboard mode. The ON position is down; OFF is up.

N O

1 2 3 4 5 6 7 8

KBD300A REAR PANEL

Figure 29. KBD300A Keyboard Rear Panel

2.To set the keyboard address, move switches 1 to 4 to the appropriate position, as described in Table H. The address must be the same as the address configured on the Communications tab (refer to the Add a KBD300A Keyboard section in the VMX300(-E) Server Configuration Manual for more information). Each address on a particular serial port must be unique.

30 C1552M-C (7/07)