8 TEST RUN
In case of wireless remote controller
Procedure | Description |
|
|
1 | Remove a small screw which fixes the nameplate of the receiver unit. |
Remove the nameplate of the sensor section by inserting a minus screwdriver, etc into the notch at the bottom | |
| of the plate, and set the Dip switch to [TEST RUN ON]. |
Execute a test operation with button on the wireless remote controller.
2 | • |
| , |
| , and | LED flash during test operation. | |
|
| ||||||
|
| ||||||
• Under status of [TEST RUN ON], the temperature adjustment from the wireless remote controller is invalid. | |||||||
| |||||||
| Do not use this method in the operation other than test operation because the equipment is damaged. | ||||||
|
|
|
|
| |||
3 | Use either COOL or HEAT operation mode for a test operation. | ||||||
* The outdoor unit does not operate approx. 3 minutes after | |||||||
|
|
|
|
| |||
4 | After the test operation finished, stop the air conditioner from the wireless remote controller, and return Dip | ||||||
switch of the receiver section as before. | |||||||
| |||||||
| (A | ||||||
| operation.) |
|
Receiver unit
Spacer
M4 × 25 screw (2 pieces)
Notch Nameplate
Small screw
17