FIREBOX PANELS INSTALLATION
(HERRINGBONE | .................. TCPN.7566) |
(TUSCAN | TCPN.748) |
(HERITAGE RED | ................ TCPN.75704) |
For porcelin panel kit (TCPN.75702) installation see in- structions provided with panel kit.
The Firebox Panels have to be installed for safe operation. Do not use the fi replace without panels. Unpack and inspect all panels. The panels need to be installed before the logs are in place.
Caution: The Brick Panels are very fragile, and should be handled with care.
1)Remove the log grate by removing the two screws retaining it. Screws are located behind the front legs of the grate.
2)Remove the Side Panel Retainers located on the underside of the upper fi rebox heatshield. The retainers are each held in place by one screw.
3)Install the Lower Rear Panel.
4)Install the Right Side Panel by inserting the bottom of the panel in fi rst and then angling it up into position.
5)Install the Left Side Panel by inserting the bottom of the panel in fi rst and then angling it up into position.
The rear panel is held tight against the side panels by two "V" brackets located on the firebox rear wall. Although the brackets are adjusted at the factory for the best fi t, some adjustment may be necessary. Adjust the angle of the bracket by hand to ensure a snug fi t.
Fig. #32 | ADJUSTABLE "V" BRACKET |
|
REAR LOWER PANEL
6)Install the Rear Upper Panel.
7)
8)Install the Left and Right Front Panels.
9)Replace the Grate.
Fig. # 31
REAR UPPER PANEL
LEFT SIDE PANEL
HERRINGBONE PANEL SET SHOWN
RIGHT SIDE
PANEL
REAR LOWER
PANEL
LEFT FRONT | RIGHT FRONT |
PANEL | PANEL |
22 36ARB2 |
