xp CDR 800/17.1 eng. 25-07-2001 15:12 Pagina 13

Installation

Digital coaxial connections via a digital receiver

If you have a receiver with digital coaxial in- and outputs, these connections allow you to make digital recordings from various sources, connected to the receiver.

 

DIGITAL

1

RECEIVER

 

Demo mode

The demo mode displays various features of the set and will start automatically when no key has been pressed for several minutes or during Standby mode.

To cancel demo mode

0Keep STOP 9 on the set pressed for at least 5 seconds. The demo mode is cancelled permanently.

English

1

CD RECORDER

1Connect a digital coaxial cord between the DIGITAL IN- and OUT jacks on the set and e.g. the (digital) AUX in- and output jacks on the digital receiver.

Any digital device, connected to the digital input jacks of the digital receiver (e.g. CD and DVD) can now be used as recording source.

Power supply

3

The type plate is located on the rear of the set.

1Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organisation.

2Make sure all connections have been made before switching on the AC power supply.

3Connect the power cord supplied to AC MAINS ~ and to the wall outlet.This switches on the AC power supply.

4Press POWER to switch on the set.

WELCOME TO PHILIPS AUDIO will be displayed.

0Press POWER again to switch off the set.

When the set is switched off, it is still consuming some power.To disconnect the set from the power completely, remove the power plug from the wall outlet.

13

Page 16
Image 16
Philips CDR800 manual Demo mode, Power supply, Digital coaxial connections via a digital receiver, To cancel demo mode