Connect wires
Note
•• Make sure that all loose leads are insulated with electrical tape.
•• Consult a professional to connect wires as instructed below.
•• Before connection, check the car's wiring carefully.
1 Connect the ISO male connectors.
| ISO male connectors | Connect to |
1 | Green strip, black- | Rear left speaker |
| edged green strip |
|
2 | White strip, black- | Front left speaker |
| edged white strip |
|
3 | Gray strip, black- | Front right speaker |
| edged gray strip |
|
4 | Purple strip, black- | Rear right speaker |
| edged purple strip |
|
e | Red strip | Ignition key +12V |
|
| DC when ON/ACC |
f | Blue strip | Motor/electric |
|
| antenna relay |
|
| control lead |
g | Blue strip, white strip | Amplifier relay |
|
| control lead |
h | Black strip | Ground |
i | Yellow strip | The +12V car |
|
| battery which is |
|
| energized at all times |
2 Connect other wires if necessary.
Caution
•• To avoid an accident, the driver must not watch video while driving. By design, this system disallows watching video during drive. Park your car in a safe place and engage the parking brake before watching video.
Note
•• When the parking brake of your vehicle is not engaged, the video blocking system is activated. It blocks the display of front video source only.
•• If the system is not properly connected with the parking brake control module of your vehicle, video signals will be blocked by the system, with the below message displayed on the TFT.
8EN
