5 First installation
Your receiver is connected to the cable wall socket,TV set and other equipment according to the diagrams in chapter Quick installation.
1Switch on your TV set and select a channel.
2 Plug your receiver into the mains.Wait for | EN |
approximately 20 seconds for the welcome screen |
|
to appear. |
|
3Wait for a few seconds for the First installation screen to appear.
5.1 First installation settings
4Set your favourite Language setting.
5Set your TV display format.
6Press OK to start scanning for channels.
5.2 Channel scan
During the scanning process, the following information is reported on screen:
•number of TV and radio channels detected
•scanning progress, indicated as a percentage
•strength of the signal and the quality of reception.
Channel scan may take up to twenty minutes. If you press
EXIT during the scanning process, you interrupt the
scanning. In this case, none of the channels found are stored.
When scanning has been successfully completed, a completion message is displayed.
7Press OK; a new screen appears indicating that a search for new software is in progress.
8Press EXIT to stop searching and tune the receiver to the first channel in the main TV list.
Alternatively, wait for software detection, and then proceed as described in paragraph 10.5.5.2.
63
