Connecting the DR500 to Your Monaural System
To connect the DR500 to a monaural system, refer to the figure below and the following instructions.
1. Make | sure |
the monaural amplifier is OFF and the volume is turned completely down. |
|
2.Connect an RCA cable to the MONO jack on the back of the DR500.
3.Connect the other end of the RCA cable to any available input on the monaural equipment EXCEPT the phonograph input.
Do not connect the RCA cables from the DR500 to the PHONO input of audio equipment. Any line level input such as AUX, CD, DAT, TAPE, VIDEO, or VCR can be used for the DR500 output.
4.Plug the DR500 into an AC outlet.
5.Continue on to Section 3: Basic Operations.
If the Audio Equipment Has a Direct Digital Coaxial Input
To connect the DR500 to audio equipment with direct digital input, refer to the figure below and the following instructions.
Connect a shielded RCA cable (not provided) from the DIGITAL OUT connector on the DR500 to the coaxial DIGITAL INPUT connector on the audio equipment. (See your stereo manual for specific requirements.) The default output format is uncompressed PCM; it may optionally be configured as Dolby Digital.
DR500
Rev. C 10/94
