Problem | Possible Causes | Solutions |
|
|
|
No sound | The stereo is turned off or the volume is turned | Turn on the stereo and adjust the volume. |
| down. |
|
| The DR500 Receiver volume is turned down. | Turn the volume up on the DR500 |
|
| Receiver. |
| The Mute function is selected. | To return to normal volume, press MUTE |
|
| on your remote control. |
| You are not authorized to receive the current | Tune to an authorized channel (refer to |
| channel. | Section 3). Contact your DMX affiliate if |
|
| you wish to receive the music channel. |
| The DR500 and stereo connectors are not | Check all DR500 and stereo connections. |
| correctly attached. |
|
|
|
|
No sound from one | Balance is incorrectly set or stereo/speaker | Adjust the balance controls on your stereo |
speaker | connections are not correctly adjusted. | and check all connectors. |
|
|
|
Remote control does | The remote control is not pointed at the | Point the remote control directly at the |
not operate the DR500 | DR500. | DR500. Ensure that there are no obstacles |
|
| between the DR500 and the remote control |
|
| unit. |
| The remote control is too far from the DR500. | Move to within 10 meters of the DR500. |
| The path between the DR500 and remote | Remove the obstruction, point the remote |
| control is obstructed. | control directly at the DR500. |
| The DMX/DJ mode is not set to the correct | Ensure that the DMX/DJ mode is set |
| mode. | correctly. You will see DMX appear on |
|
| the DMX/DJ display (refer to Section 1). |
| Front panel lockout is set. | Unlock the front panel (refer to Section 4). |
| The remote control batteries are run down. | Replace all remote control batteries. |
| Remote control is broken. | Check that the remote control is |
|
| functioning properly by performing the |
|
| procedure for viewing the time on the |
|
| DMX/DJ. |
|
|
|
DR500
Rev. C 10/94