Philips DR500 manual Checking Dynamic Range Settings, Clearing the Dynamic Range

Checking Dynamic Range Settings

To check the dynamic range for a specific channel:

1.Tune to the desired channel.

2.Press:

PRESET 1 1 0

The front panel flashes the current dynamic range code (00-03) for this channel. If a specific dynamic range has not been set, the front panel displays a flashing three-digit number representing the global default for that channel.

Clearing the Dynamic Range

The DR500 allows you to program and store up to 10 channels with specific dynamic range settings. If you have exceeded the 10-channel maximum, the DR500 front panel displays FUL indicating the memory is full. When FUL displays, the DR500 memory must be cleared before additional dynamic range settings can be entered. To clear the DR500 memory, press:

PRESET 5 1 0

The front panel will momentarily display CLr as the DR500 clears all dynamic range settings from memory. When the DR500 has finished clearing all settings, the current channel displays.

Setting the Dynamic Range Global Default

To set one dynamic range for all authorized channels:

1.Press:

PRESET 9 6 0

2.Enter the dynamic range code. Press the appropriate number (or use the TUNEÙ and TUNEÚ buttons to make your selection), then press STORE.

# STORE

All channels are set to the specified dynamic range. To change or clear the global dynamic range default setting, repeat this procedure.

DR500 (E-34)

Rev. C 10/94