Philips HFL3008W, HFL3008D user manual Change professional mode settings

To view the hotel information screen by pressing INFO, in the professional setup

menu, select [Hotel information] > [Info key enable] > [On].

Change professional mode settings

Professional mode settings

Use professional-mode settings to speed up installation of your TV for commercial use.

1.In the professional setup menu, select [Professional Settings], then press OK.

2.Select a setting to change, then press OK: ∙ [Room ID]: Set a Room ID for the TV. ∙ [Consumer setup]: Shortcut to the full

TV menu to configure all the TV

settings.

∙ [Channel setup]: Shortcut to channel list where you can re-arrange, rename and hide channels.

∙ [USB to TV]: Clone settings stored on a USB storage device from another

Philips TV to your TV.

∙ [TV to USB]: Copy your TV's settings to a USB storage device. These settings can be cloned onto another Philips TV.

∙ [RF to TV]: Copy settings from a Philips

TV using RF signal.

∙ [Reset]: Reset all professional mode settings to the factory default.

Installation settings

Use these settings to configure installation settings.

1.In the professional setup menu, select [Installation].

2.Select a setting to change, then press OK: ∙ [Blank channel]: Select a channel to

play audio only.

∙ [Auto channel update]: Update

channels automatically.

∙ [Auto software update]: Update your

TV software automatically.

∙ [Skip scrambled signals]: Enable or disable scrambled channels in the

channel list.

∙ [Multi remote control]: Select an option to identify a paired remote control.

∙ [MyChoice]: Enable or disable MyChoice channels.

∙[ThemeTV]: Enable or disable Theme TV.

∙[SmartPay]: Enable or disable SmartPay.

Pairing TVs with a remote control

You can pair a TV with up to ten remote controls.

1.In the professional setup menu, select [Installation] > [Multi remote control].

2.Select an option from [TV0] to [TV9] to

identify the paired remote control, then press OK.

3.To set the remote control in a specific mode, simultaneously press and a number

key for 5 seconds to set the remote control in the [TV0] to [TV9] mode.

Note:

∙Press and hold OK on a remote control for more than five seconds. The

TV displays the TV ID (for example, [TV0]) as well as the ID of the transmitting remote control.

∙If the batteries in the remote control are replaced after pairing, you will need to pair the remote control with your TV again to assign an ID to your TV.

Power-on settings

Customise the way the TV behaves when it is switched on.

1.In the professional setup menu, select [Switch on setting].

2.Select a setting to change, then press OK:

∙ [Switch on channel]: Select a channel

to display when the TV is switched on. ∙ [Switch on vol]: Select the volume of

the speakers to be used when the TV is

switched on.

∙ [Max volume]: Limit the maximum

volume of the TV.

∙ [Switch on picture format]: Select a picture format to be used when the TV

is switched on. If the source does not support the pre-defined format, [Auto fill] is enabled.

∙ [Power on]: Select the mode to be used when the TV is switched on:

-[On]: If the mains power is switched

on, the TV automatically switches on. - [Standby]: If the mains power is

EN 17

English