| Operating Instructions |
| About Network Camera Setup |
|
|
Problem | Cause and Remedy |
|
|
Power Indicator | • Internal Failure of the server or the congestion on the network |
continues | traffic when using DHCP may prevent Network Camera from |
blinking. | getting the IP address. Ask the network administrator or your |
| ISP. |
| • Power Indicator blinks when updating firmware on page 82. |
| When the Update Firmware failed, refer to page 108. |
| • If you cannot access Network Camera, the Network Camera |
| hardware may be defective. Call our customer call center. |
|
|
Image Transfer | • Default Gateway and DNS server address should be set up on |
on | Network window on page 50. |
does not work. | • If FTP does not work properly, ask your ISP or network |
| |
| administrator about the transferring mode of FTP server. |
| [Passive Mode] or [Active Mode] is available. |
| • Select [One Time] for Login Timing when transferring images |
| by FTP in short duration time. |
|
|
Timer mode | Short interval of Image Buffer Frequency makes Network Camera |
transfers older | transfer the older images. Set the interval long enough to transfer |
images. | the images. Buffered Image screen enables you to check this |
| setting. |
|
|
[For assistance, please call: | 107 |
