1.Press the START/STOP button.

The program number (1) flashes on/off.

2.Press the SET button. The start hours flash on/ off.

3.Press the UP or DOWN button until the desired number appears on the monitor.

4.Press the SET button. The start minutes flash on/off.

5.Press the UP or DOWN button until the desired number appears on the monitor.

6.Press the SET button. The stop hours flash on/ off.

7.Repeat steps 3 through 5 to set the stop hours and minutes.

8.Press the SET button. The timer recording speed flashes on/off.

9.Press the UP or DOWN button until the desired number appears on the monitor.

10.Press the SET button after setting the timer recording speed. The program number of the next lower line flashes on/off.

11.Repeat steps 2 through 9 to set the program to the other program numbers.

12.Press the SET button after setting the program numbers (1) through (7).

The two program event locations of MON flash on/off.

13.Press the SET button. The first program event location of MON flashes.

14.Press the UP or DOWN button until the desired program number appears on the monitor.

15.Press the SET button. The other program event location of MON flashes on/off.

16.Press the UP or DOWN button until the desired program number appears on the monitor.

Notes:

If you do not need to timer record two events a day, mark either event with an asterisk ().

If two asterisks are displayed, no timer record- ing is made on that day.

17.After setting two program event locations of MON, press the SET button. The two program event locations of the next day of the week flashes on/off.

18.Press the SET button. The first program event location of the next day flashes.

19.Repeat steps 12 through 16 to set the program event locations up to SUN.

20.Press the START/STOP button when the TIMER has been set.

Notes:

1.Programming the TIMER function does not acti- vate it. See TIMER recording, page 21.

2.To record the time and date press the PROGRAM button to display them.

3.When the preset START time is later than the STOP time, the recording will be made into the following day.

4.When the START time and STOP time are the same, a recording will not be made.

5.When the programs for timer recording overlap each other, recording will be switched to the pro- gram with the later recording start time.

Example

• • • • • Record

Program number 1

Program number 2

Time

Program number 3

When recording of program number 3 is terminated, program number 2 will be recorded for its remaining time.

6.When two programs have the same start time, the program number with the earlier stop time has priority.

To correct information

1.Press the START/STOP button.

2.Press the UP or DOWN button repeatedly until the item to be corrected (Program number or program event location of day of the week) flashes on/off.

3.When the section to be corrected flashes on/off, press the SET button.

Press the SET button again so that only the digit to be corrected flashes on/off.

4.Press the UP or DOWN button to correct the set information.

5.After completing the correction, press the START/STOP button.

16

Page 17
Image 17
Philips LTC 3963/51 manual To correct information, Example