Getting Started
E n g l i s h
Step 1: Inserting batteries into the remote control
3
1
2
1Open the battery compartment.
2Insert two batteries type R06 or AA, following the indications
compartment.
3Close the cover.
Using the remote control to operate the system
Step 2: Setting the clock
The clock can be set in either
example).
buttons on | DVD system’s |
front panel | display panel |
CLOCK•TIMER |
|
2 | SELECT CLOCK OR TIMER |
| |
CLOCK•TIMER |
|
3 | CLOCK |
| |
SEARCH |
|
4 | 01:38 PM |
PROG |
|
5 | 13:38 |
CLOCK•TIMER
613:38
1 Press STANDBY ON to switch on the DVD |
1Aim the remote control directly at the remote sensor (iR) on the front panel.
2Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TV/AV,TUNER).
3Then select the desired function (for example ÉÅ, S, T).
OPEN•CLOSE
DISC 1 | DISC 2 | DISC 3 |
DISC 1
DISC 2
DISC 3
DISC 4
DISC 5
iR SENSOR
DISC/
TV/AV MEDIA TUNER AUX/DI
1 2 3
4 5 6
7 8 9
SURR. | 0 | SOUND |
| VOL |
|
SYSTEM MENU |
| DISC MENU |
SEATING |
| ZOOM |
PREV |
| NEXT |
OK
system. |
2Press and hold CLOCK • TIMER until
"SELECT CLOCK OR TIMER" appears.
3Press T (if necessary) to change the display to "CLOCK", then press CLOCK • TIMER again to confirm.
4Press S / T to set the minutes and hours. To increase the speed, hold down S/ T.
➜ The changes in minutes will roll over to the hours.
5 Press PROG to change between |
STOPPLAY/PAUSE
DISC SKIP REPEAT REPEAT PROGRAM
CAUTION!
–Remove batteries if they are exhausted or if the remote is not to be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed of properly.
6Press CLOCK • TIMER again to store the setting.
➜ The clock will start working.
To view the clock time in any active mode
●Press CLOCK •TIMER.
➜ The clock will display for a few seconds.
Notes:
–If the DVD system is disconnected from the power supply, it will erase the clock setting.
–If you do not press any buttons within 90 seconds, the system will exit clock setting mode.
18
